Fitting the Matter Key Turn sensors
A key-both-sides door gets two sensors, one inside and one outside. Each one pairs with your smart home hub on its own, so your home app shows two lock tiles for the door unless you add the optional Locksure Matter Hub, which combines them into one Locksure door. The physical fit is the same as the Original Key Turn monitors.
Check first: one compatible smart home hub, and both sides of the door pass the three fit checks.
Before you start: one sensor at a time
Leave the second sensor’s battery out until the first one is fitted and paired. Both sensors look the same to your home app during setup, and having two awake at once can make pairing pick the wrong one.
Physical fit (both sides)
Follow steps 2 to 10 of Fitting the Key Turn monitors: clean, test the bracket, fit the battery, fit the bracket, fit the sensor, fit the key disc, then lock and unlock with the key until the lights agree with the lock (cyan for locked, amber for unlocked).
Pair the first sensor
- Open your home app and choose Add accessory or add a device.
- Scan the QR code on the card in the box.
- Name it, for example “Front door inside”.
- Lock and unlock once and check the tile changes.
Fit and pair the second sensor
Fit the second sensor on the other side of the door, put its battery in, then pair it the same way. Name it, for example “Front door outside”.
Seeing both sides as one door
In Apple Home, Google Home and the other home apps, the two sensors stay as two tiles; each reports the lock state it saw. Whichever side turned the key last is the one that updated. If you want one door in the Locksure app that follows the lock whichever side was used, add the Locksure Matter Hub and assign both sensors to one door.
Troubleshooting
- Pairing finds the wrong sensor: take the other sensor’s battery out and try again.
- One side never updates: check that side’s lights flash when the key turns. If not, see Not detecting.
- Door shows unlocked after locking from outside: the inside sensor’s tile is showing the earlier state. The Locksure Matter Hub resolves this; without it, read the tile of the side that was used.
- If the sensor’s lights have stopped flashing during setup, take the battery out for a few seconds and put it back. The sensor starts setup again. If you pressed the settings pin, check afterwards that locking shows locked; if not, see Changing the setting in the Matter Thumb Turn guide.
Full pairing detail for each home app is in Pairing a Matter sensor.
Was this page helpful?
Thank you. If you still need help, email support.